I was listening to my tuner last week and suddenly there was a weird kind of time warp distorted sound that started coming from both channels.I rushed over to my amp and turned it off. When I powered it up again I got distorted sound from both channels. Bad distortion. I tried different sources and got the same thing. I suspect a bad tube in the PV-11 since my amp is the solid-state Conrad Johnson MF-2200.
Thing is all the tubes in the pre-amp still glow. Am I wrong in thinking it's a tube? What should I look for here?
Thanks in advance for all replies.
Suspected Tube Out In PV11 Or Could It Be Another Culprit?
- Gregory Earl
- Regular
- Posts: 7
- Joined: Sat May 16, 2015 10:56 am
- AnotherJohnson
- Ultimate
- Posts: 5219
- Joined: Sun Apr 26, 2020 12:29 pm
- Location: Tennessee
Re: Suspected Tube Out In PV11 Or Could It Be Another Culprit?
Glowing is not a sign of a good tube. Not glowing is a sure sign of a problem, but glowing by itself means nothing (unless it is the relentless glow of a runaway Power tube, in which case it’s a bad thing). Test the tubes, or replace them with known good ones if you can’t test them. Talk to CJ directly. I’ve never had bad advice from them.
Last edited by AnotherJohnson on Tue Jun 16, 2020 4:09 pm, edited 1 time in total.
It’s just stuff. I like mine. I hope you like yours. I probably like yours too.
- AnotherJohnson
- Ultimate
- Posts: 5219
- Joined: Sun Apr 26, 2020 12:29 pm
- Location: Tennessee
Re: Suspected Tube Out In PV11 Or Could It Be Another Culprit?
You might contact CJ directly. It may take a few days ( be patient), but my experience has been that CJ can be very helpful in chasing down problems. No one knows their gear better, and they have seen it all. They are patient, especially if you are not arrogant or pigheaded.
They have saved me countless hours of troubleshooting by steering me toward the most likely culprit.
They have saved me countless hours of troubleshooting by steering me toward the most likely culprit.
Last edited by AnotherJohnson on Tue Jun 16, 2020 4:06 pm, edited 2 times in total.
It’s just stuff. I like mine. I hope you like yours. I probably like yours too.
- AnotherJohnson
- Ultimate
- Posts: 5219
- Joined: Sun Apr 26, 2020 12:29 pm
- Location: Tennessee
Re: Suspected Tube Out In PV11 Or Could It Be Another Culprit?
The other thing would be to take a look at the caps in either (both) units (amp and preamp). Any signs of leaking or discoloration or bulging, and that’s an obvious clue too.
A dirty volume pot could also be the culprit. It is even possible for transistors to fail with age and use.
So ... while tubes are an obvious and somewhat easy place to start, it is definitely possible for older solid state gear to fail too. Sadly I know this from nursing old solid state gear along through assorted refurbishments.
A dirty volume pot could also be the culprit. It is even possible for transistors to fail with age and use.
So ... while tubes are an obvious and somewhat easy place to start, it is definitely possible for older solid state gear to fail too. Sadly I know this from nursing old solid state gear along through assorted refurbishments.
It’s just stuff. I like mine. I hope you like yours. I probably like yours too.
Re: Suspected Tube Out In PV11 Or Could It Be Another Culprit?
Hola Gregory,
I do believe that you have an open bias fuse...Check the fuses, that's why the sound is distorting. A bias voltage is not present, and this voltage is for all power tubes.
It is good advice from AJ to ask at Conrad Johnson an advice for this problem.
Happy listening!
I do believe that you have an open bias fuse...Check the fuses, that's why the sound is distorting. A bias voltage is not present, and this voltage is for all power tubes.
It is good advice from AJ to ask at Conrad Johnson an advice for this problem.
Happy listening!
ML CLX BF-210 Stage X Motion 4. CJ 120SE amp ET7V2 pre, Holo May Kte Dac. Mac Pro. Power Cond. BPT Signature+ 3.5, Gaia II Feet. USB Lush^V3. Nordost SPM IC and Spk. Shun Mook, BCanto CD2 CD3. Linn LP-12/Unitrack tonearm/Denon DL103R MC.
- AnotherJohnson
- Ultimate
- Posts: 5219
- Joined: Sun Apr 26, 2020 12:29 pm
- Location: Tennessee
Re: Suspected Tube Out In PV11 Or Could It Be Another Culprit?
Something really cool from CJ about the PV 11 that I missed.
Circuit Upgrades
PV10 (including 10A and 10B), PV11, and PV12 preamplifiers can be upgraded to incorporate our latest enhanced triode (ET) – circuitry and can also be upgraded to include CJD Teflon capacitors.
Circuit Upgrades
PV10 (including 10A and 10B), PV11, and PV12 preamplifiers can be upgraded to incorporate our latest enhanced triode (ET) – circuitry and can also be upgraded to include CJD Teflon capacitors.
It’s just stuff. I like mine. I hope you like yours. I probably like yours too.